avatar

By ForeverGreen

August 4, 2020, 3:10 pm

Finish speeds and feeds

All of the speeds output by HSMAdvisor seem to be roughing speeds and feeds. How about a finishing button? Or is there already a way, that I'm not seeing?

FINISH.png FINISH.png
Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

August 5, 2020, 10:35 pm

Hi,

Yes, you are right. The Speeds and Feeds are suggested for medium roughing operations.
One way to select finishing is to:

* Turn Performance Slider to the minimum
* Set the feed rate override to 50%
* Enable HSM checkbox

But I believe you as a machinist would have a better idea in regards to finishing feed rate depending on your finish and tolerance requirements.

I tried to add the "Finishing button" feature based on the recommendations above but it just looks like too broad of a rule of thumb and it does not work in all cases.
So it is still up in the air.

Best regards.

avatar

ForeverGreen

August 6, 2020, 6:15 am

May I ask what the reasoning is behind enabling the HSM checkbox?

avatar

Eldar Gerfanov (Admin)

August 6, 2020, 7:20 am

It will allow to increase spindle speed according to lower WOC.

avatar

ForeverGreen

August 6, 2020, 11:36 am

Gotcha. Thanks for your help.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here