Latest Responses

By DaveF

October 2, 2018, 5:17 am

Tapered cutters

I may be missing something really obvious , but I cant see any option for inputting spec for tapered cutters?
Thanks in advance for any help.

cant leave messages here
Pages:(1) [1]

Eldar Gerfanov

October 2, 2018, 8:38 am


There is no special "Tapered End Mill" tool type.
Rather is is achieved by entering a "Taper/Lead/Tip" angle value. You can click on the angle icon to change the type of angle you are entering.

Tapered tools are calculated according to the parameters entered, so it is important to specify actual geometry.

Please check the attached screenshot for reference.

Best regards!

Capture_taperedEM.PNG Capture_taperedEM.PNG


October 2, 2018, 8:57 am

Got it!
Thanks for the prompt reply Eldar. Were finding the software very useful.
Do you happen to have specs for a Hurco vmx 42i?
Thanks again


Eldar Gerfanov

October 2, 2018, 11:12 am


I do not have that specific machine.

But if you click "Download" on the Machine Definitions window, you can find a machine, close to yours in spindle RPM and HP.
If it says "public-admin" on it, it means the machine was created by me and is accurate and has Power Curve defined.

I am going to see if i have time to create it today or tomorrow.


© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here