July 11, 2017, 1:15 pm

Cutting Force

when using HSM Advisor I carefuly look at Deflection of tool - with small tools, that is the weakest point when things go bad.

With larger tools I also look at "Cutting Force" because there is the limit/weak point of machine construction. (mainly hobby machines) Experimentaly I found for my machine, where is approximately the limit from where the milling is noisy and makes bad surface.

It will be nice if in machine definition I could define "Cutting Force" and in "Load limits" I could see percentualy where I am.

cant leave messages here
Pages:(1) [1]

Eldar Gerfanov (Admin)

July 11, 2017, 5:58 pm

Thanks for the suggestion.

I will look into adding the force display gage.
By the way you can specify your default deflection and torque values in the settings.




March 2, 2018, 9:26 am

Did you change calculation of "Cutting Force" in new versions 2018 ?

I did not write it down, but my mostly used tool+maaterial+DOC+WOC gave me cutting force somewhere aroud 50-60N and now it is around 3-5N


Eldar Gerfanov (Admin)

March 4, 2018, 12:47 pm
Updated by: Eldar Gerfanov (Admin)March 4, 2018, 12:47 pm


Yes there is an error is output of the cutting force in mertic format.

It does not affect anything else.

I will fix it in the next update.

Thank you for reporting the issue!


Eldar Gerfanov (Admin)

March 4, 2018, 5:58 pm


Thanks to your feedback I fond a critical issue in metric mode.

Please download and install an update.

Best reagrds!

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here