It would be cool if we could have buttons near DOC and WOC to automatically adjust each respectively to maximize MRR. So I could pick a material, define a tool, turn Chip Thinning and HSM on or off, and [set the DOC, and click to optimize MRR by adjusting WOC], or [set the WOC and click to optimize MRR by adjusting DOC].
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Updated by: Eldar Gerfanov (Admin) August 14, 2015, 12:18 am
It already does that! Let me know if this is what you had in mind.
https://hsmadvisor.com/help?article_id=4435
mhajicek
Cool, didn't know that the labels were clickable. What would you think of making them look like buttons?
mhajicek
Hmm. I just did an experiment. 5/8 flat EM, 4 flute, carbide, TiAlN, default (green) other stuff. Chip thinning and HSM turned on, DOC & WOC green. MRR = 4.91. Then I manually reduce WOC to 0.030 and MRR = 7.06. Tool life is sacrificed for a higher MRR.
Eldar Gerfanov (Admin)