By Thoobhertz

May 26, 2015, 7:51 am

Update feed

Hey guys, I'm trying to get my feed to update based on my parameters but they don't move at all. I'm using a 3/8 indexable bullnose cutter and I'm trying to surface an angle on a part. Does not matter what parameters I use, ie depth, width, hsm, chip thinning, the feed on the right does not change. I used to use this program a lot more where i used to work and it used to update automatically everytime I selected different parameters. Am i missing something? Why is it not updating?

cant leave messages here
Pages:(1) [1]


May 26, 2015, 7:52 am

Nevermind. I'm an idiot. I set my max feed in metric by mistake. I was hitting max feed. I adjusted it to imperial and it updated. :blink:

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here