avatar

By Aero

May 11, 2015, 4:45 pm

WHAT HAPPENED TO BORING BAR SIZE?

have downloaded the new version and found that the boring bar size is missing or I can not find it

it was there before, been awhile since I have used the program so not sure what version it went missing

I use a number of small boring bars and need to enter the size of it as the numbers your program is putting out I am sure would destroy my boring bars

will check the threading bar part of the program and see if they have bar size as well

0.15 inch DOC and a chip load of 0.00843 inches per rev for a boring bar only 0.3 inches big with a 1 inch stick out seams high. I could be wrong but why no bar size setting any more? I could have a bar size of 0.15 inch or even smaller, there is no way I can see to set the bar size

let me know if I am missing something

thanks

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Aero

May 11, 2015, 5:54 pm

my bad

found it

sorry for the post

avatar

Eldar Gerfanov (Admin)

May 11, 2015, 5:58 pm

Quote:"AERO"
my bad

found it

sorry for the post


Yes, you need to expand the Tool Data panel to access the boring bar size field.
Glad you have figured it out.

Cheers!
:ernaehrung004:

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here