Latest Responses

By Aero

February 19, 2015, 6:04 pm

boring bar holder size makes no difference

changing the boring bar holder size makes no difference at all

I am sure this needs looking into, the bar I am using is 0.300 inch round and the DOC is 0.05 in 12L14, the program says I can cut at 0.0135 per rev

even when I set holder size to 0.05 it still says I can cut at 0.0135, I am guessing this is very wrong

am I wrong in thinking that the program should limit DOC and feed speeds based on holder size and material being cut?

just asking if I found a bug or if I am expecting to much, tool deflection estimate would be helpful as well

cant leave messages here
Pages:(1) [1]

Eldar Gerfanov

February 19, 2015, 7:38 pm
Updated by: Eldar GerfanovFebruary 19, 2015, 8:37 pm


I have just fixed the reported issue along with some other things.
Please download an update.

There will be a big overhaul of turning side not too far in the future, i will look into adding Deflection calculation for turning amongst other things.

Thank you
Best Regards

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here