By Blue_Chips
September 22, 2014, 8:11 am
Slitting Saw
Hello Eldar Is there a tool and settings that would be appropriate for slitting saws? Thanks
Latest Responses
- Circle/Ramp can't select ramp plunging
- Add TiB2 coating?
- Ball endmill/surfacing example
- Drilling - Cutting Force is Broken
- The RPM seems to max out at 10,000
- Tormach PCNC 440 / lower horsepower machine best practices for building CAM using Fusion360 and HSMAdvisor
- Am I using HSMA incorrectly?
- HSMA speeds and feeds with plastic and O-flutes
- High Feed end mill configuration
- molybdenum
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Hi, You can use solid endmill tool type. Just make sure you enter your arbor diameter as shank dia. Also enter number of teeth, helix angle=0. And stickout. Watch for your power consumption and just to be safe, start with 30% feed override on the machine. Everything depends on chip clearance, so be careful with flutes galling up. Good luck!