Latest Responses
Username:
Password:
avatar

By sn4k3

August 28, 2020, 7:53 pm

Configuring chamfers and vbits with sharp tips

I'm having trouble seting up chamfers and vbits because of tip diameter. I'm unsure what to set there, i think a check box with a option for "Sharp tip" should be included on this two types and tip diameter should be used for max blade diameter to enforce min/max calculations.

With a vbit of 32mm max diameter, 20mm flute length, 90º, I'm setting tip diameter to: 0.1mm to be sharp, this cause almost correct WOC, for example: 2mm DOC, WOC is auto set to 4.1mm, that +"0.1" wouldn't hurt but because of 0.1mm tip diameter feeds are very slow and plunge of 84mm/min are ugly. Same happens with chamfers.

What is the correct way to configure them to give the correct feeds?

Also i like to ask if there any difference on vbits VS chamfers on the program output, both types seen equal results

HSMAdvisor_2020-08-29_01-53-05.png HSMAdvisor_2020-08-29_01-53-05.png

Answers:

cant leave messages here

© 2009-2018 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here