Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>General Discussion >>Corner Rounding End Mill FSwizard and HSMA
avatar

By riplash2008

July 5, 2023, 10:29 am

Corner Rounding End Mill FSwizard and HSMA

Hello All, I have a question about the best way to put in a corner rounding end mill for FSwizard and HSMA to get speeds and feeds. I have a generic 1" dia carbide 4F 1/4" radius, with a 1/2" pilot or tip radius. I am planning on putting it in as chamfer end mill with 1/2" tip 90 degree included angle and .250 flute length and 1" shank. Is this the best way to approximate the end mill? Do you have better ways to enter the end mill? Thanks, Ryan

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

July 11, 2023, 10:13 pm

Hello, Yes, a corner radius end mill can be approximated by the chamfer end mill like that. Just make sure to slow (both speed and feed) down by an additional 25% because the length of the cutting edge is larger and there is more force acting upon the tool. Best regards.

avatar

riplash2008

July 12, 2023, 7:44 am

Okay thanks for the confirmation and the suggestion to slow the feed and speed down by 25%. We will be cutting with that old, but new to us end mill today. Ryan

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here