Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>HSMAdvisor Support Forum >>Finish Speeds
avatar

By ChipX

October 18, 2015, 6:10 pm

Finish Speeds

Hi there, I'm just wondering if someone can tell me what the best practice is for calculating finish feeds & speeds using HSMAdvisor? GWizard has its Turtle <> Hare slider bar, which controls how aggressive the roughing cuts are, but on the lowest setting defines itself as a finishing cut. I haven't found any documentation in the help files, tutorials or on this forum for finishing passes, so I thought I would create a thread and ask. Cheers Scott.

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

October 18, 2015, 9:18 pm
Updated by: Eldar Gerfanov (Admin)October 18, 2015, 9:43 pm

I am working om some sort of presets that would automatically adjust levels to simulate various machining modes. Including finishing. Right now the best way is to enter the real cut info Reduce "Performace Slider" to minimum , Enable "HSM" and disable "Chip Thinning". Regards.

avatar

ChipX

November 4, 2015, 3:03 pm

Good to know. Thanks.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here