Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>General Discussion >>Need help with machine definition file
avatar

By robstah

May 14, 2015, 9:02 pm

Need help with machine definition file

Hey guys, I am looking to develop a machine definition file for my FADAL VMC20. I've got the following info from the machine itself: - Baldor 5HP 3phase, 215TC frame, 230volt, 15.6amp, 1160rpm @ 60hz - Baldor H2 VS1SP210-1B 10HP spindle inverter drive - 10k RPM HI/LOW spindle (LOW = 45RPM to 2500RPM, HI = 2500RPM to 6500RPM), machine set to 6500RPM max I'm trying to figure out the torque curve and how that applies to the HI/LOW spindle setup and if it is worth setting the machine up for 10k RPM or not (if I even have torque there or not, apparently the spindle can handle it). Thanks for all the help!

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

May 15, 2015, 8:25 pm

No worries. I can make a definition for you and you will just import it into HSMAdvisor. I can not quite make out what some of your numbers mean exactly. Just answer these questions for me: *Spindle Low Range Peak Horsepower RPM (at what RPM you get peak Power output) *High range Peak Horsepower RPM *Motor HP at maximum RPM I do not NEED them, but if i had that info, i would be able to build a more accurate chart for you. Regards.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here