Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>General Discussion >>Mastercam X9 CHook
avatar

By wjimenez_cw

February 1, 2016, 11:52 pm

Mastercam X9 CHook

Hi Eldar, This past week and today I have used the boring head calculator and found that HSM is not reading the Boring Bar Definition the first time it loads the tool in; see below, once I manually select Boring Head it sticks. Additionally, I noticed that the speed displayed in HSM is imported to 4 decimal places in Mastercam. Regards, Bill

Mastercam_Tool Mastercam_Tool.jpg First_Time First_Load_HSM.jpg Second_Time Second_Load_HSM_Manual.jpg Feed_2Place Feed_2Place.jpg Feed_4Place.jpg Feed_4Place.jpg

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

February 2, 2016, 10:44 am

Hello Bill, Turns out I did not add support for Boring Head yet. Will also add rounding to SFM output. Thank you! Regards.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here