By Blue_Chips
August 21, 2014, 1:21 pm
Ball nose in tool type missing?
Hi Aldar,
Am I overlooking something? don't see Ball Nose listed in the "Tool Type" selection drop down.
Ken
Latest Responses
- New user help with entering values by Administrator on May 24
- Tool stick-out invalid by User10807 on May 11
- Thread mill RPM and resulting Feed by User10805 on April 26
- Coating Al2O3 by Administrator on April 8
- Contant Surface Speed IN LATHE by Administrator on April 3
- Resulting RPM was reduced because of the lenght of the tool? by Administrator on April 2
- Tool size limited to two digits by Administrator on March 24
- Cannot Update Tool Parameters by Administrator on March 19
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Blue_Chips
Never mind Aldar, found the ball nose selection tick box under tool data.
Ken
Administrator
Scared me for a second there!:ohmy:
Blue_Chips
Then my work is done :D
What are point micrometers used for, this one has two 60º comical points at each end?
Ken
Administrator
Updated by: AdministratorAugust 22, 2014, 7:06 pm
What are point micrometers used for, this one has two 60º comical points at each end?
Ken
Dunno. Anything that needs those conical ends to fit into something.
I am thinking about measuring wall thickness of a tube, and of a thread diameter.
Very specialized i think. Never used one like that. Never even seen one in real world.
Eldar