So I just recently started using FS wizard and Im a bit confused about the lead angle setting when using a non indexable endmill. I understand that idexable cutters have different lead angles but do standard endmills have a different lead angle than the helix angle. Any info on this would be great.
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Hello, Lead angle of a straight end mill is always 90 degrees. I recommend leaving the default fields as-is unless you know they are different. Regards.