Resources and Software For High-Performance CNC Machinists
Latest Responses
Login
Email or Username:
Password:
Register Forgot Your Password?
Forums >>HSMAdvisor Support Forum >>Inconsistent calculated values
avatar

By Ben

September 7, 2026, 11:11 am

Inconsistent calculated values

Hi, 

I observed the following behaviour: (HSMAdvisor v3.0.8)

Select any tool. Set rpm/feed/doc to suggested values (reset). Select a higher/lower DOC value outside of what appears to be a snap-range (small deviations are reset to recommended value).
Set value back to the same recommended DOC value as before. 

Feed in average stays at +200 mm/min : +28 in/min higher than initial recommended feed.

HSMAdvisor_fs_inconsistency_suggested_value1.png HSMAdvisor_fs_inconsistency_suggested_value1.png HSMAdvisor_fs_inconsistency_suggested_value2.png HSMAdvisor_fs_inconsistency_suggested_value2.png

Please register and/or log in to leave comments!
avatar

Ben

September 7, 2026, 12:13 pm

Never mind: Tested with version 3.1.1.
Issue is fixed.

avatar

Eldar Gerfanov (Admin)

September 7, 2026, 4:55 pm

Quote:"BEN"

Never mind: Tested with version 3.1.1.
Issue is fixed.

No problem and thanks for the quick update - I was going to suggest just that because I put a lot of effort into consistency improvements related to DOC/WOC. Please let me know if you see any issues in the new version. Best regards.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here