Latest Responses

By Aero

July 9, 2014, 5:23 pm

lathe parting

I am needing to setup a lathe parting cut and your program does not seem to allow that
also have a 0.165 Oring groove to cut and your program does not seem to allow that ether

there is no WOC setting I can find. I have thought I should use the lathe grooving tool but no WOC for that

any help on how I should do this?

cant leave messages here
Pages:(1) [1]

Eldar Gerfanov

July 9, 2014, 10:59 pm

Hello Aero,

There was a glitch in there, that has just been fixed.

i already uploaded the latest release and you can get it from "downloads" page.


© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here