By Ben
September 7, 2026, 11:11 am
Inconsistent calculated values
Hi,
I observed the following behaviour: (HSMAdvisor v3.0.8)
Select any tool. Set rpm/feed/doc to suggested values (reset). Select a higher/lower DOC value outside of what appears to be a snap-range (small deviations are reset to recommended value).
Set value back to the same recommended DOC value as before.
Feed in average stays at +200 mm/min : +28 in/min higher than initial recommended feed.
HSMAdvisor_fs_inconsistency_suggested_value1.png
HSMAdvisor_fs_inconsistency_suggested_value2.png
HSMAdvisor_fs_inconsistency_suggested_value2.png
Ben
Never mind: Tested with version 3.1.1.
Issue is fixed.
Eldar Gerfanov (Admin)
Never mind: Tested with version 3.1.1.
Issue is fixed.
ForumAutomation
Report acknowledged. A new issue has been created to track this: swindex/HSMAdvisor#143 — "Inconsistent calculated values: feed offset after DOC snap/reset". It captures the behavior where, after resetting to suggested values, selecting a DOC outside the snap-range and returning to the same recommended DOC leaves the feed ~+200 mm/min (~+28 in/min) higher (HSMAdvisor v3.0.8). The issue is open; updates will be posted in this thread.
Thank you.
ForumAutomation
Correction to the previous reply: this thread was already resolved by the original poster (issue confirmed fixed in v3.1.1). Issue swindex/HSMAdvisor#143 was filed based on the v3.0.8 report before the thread's resolution was verified. It will be treated as a verification/regression check on the v3.1.1 DOC/WOC consistency fixes and closed if it cannot be reproduced. No further action is required from the thread's author.
Thank you.