Resources and Software For High-Performance CNC Machinists
Latest Responses
Email or Username:
Password:
Register Forgot Your Password?
Forums >>HSMAdvisor Support Forum >>Add DLC to list of coatings
avatar

By rronald

June 12, 2026, 8:12 pm

Add DLC to list of coatings

Greetings,

I use HSM for a manual mill and a CNC mill. 

The CNC mill spins fast (6K-24K RPM) and must move pretty quick to avoid chip welding. Two big things that make it work better are mist cooling and DLC (Diamond Like Coating) on the mill. DLC is a real game changer and allows much faster speeds.

Unfortunately, I haven't been able to use HSM for the application of milling aluminum with DLC mills. W/o a selection for DLC coating, the speeds and feeds are much lower than with DLC. A 6mm endmill in aluminum (using uncoated or with any of the coatings you support) comes up with 6000-7000 RPM as the recommended speed for the mill. But I just used a DLC single flute cutter at 18000 RPM with no problem (and that was after I lowered the recommendation I got down from 22000 RPM.)

Answers:
cant leave messages here

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here