By gurusonwheels
April 5, 2021, 3:29 pm
Max feed under machine setup , whats it looking for ?
my machine specs say this . Maximum 0-4000 mm/min carving speed 0-2500 mm/min (different materials differ) so what do i enter ?
Latest Responses
- Circle/Ramp can't select ramp plunging
- Add TiB2 coating?
- Ball endmill/surfacing example
- Drilling - Cutting Force is Broken
- The RPM seems to max out at 10,000
- Tormach PCNC 440 / lower horsepower machine best practices for building CAM using Fusion360 and HSMAdvisor
- Am I using HSMA incorrectly?
- HSMA speeds and feeds with plastic and O-flutes
- High Feed end mill configuration
- molybdenum
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Hi, You would enter your maximum possible cutting feed rate. Most hobby machines are limited to 100ipm or 2540 mm/min