Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>HSMAdvisor Support Forum >>Help configuring a indexed surface mill
avatar

By sn4k3

August 19, 2020, 6:30 pm

Help configuring a indexed surface mill

I'm seeking advice to configure this face mill: https://www.aliexpress.com/item/4000070506541.html The endmill have 2 vertical flutes + 2 horizontal flutes, should i configure as 2F or 4F on HSMAdvisor? I've attached my configuration, not sure if is correct to go this way

My Settings HSMAdvisor_2020-08-20_00-24-16.png

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

August 19, 2020, 8:31 pm

Hi, That is a 2 flute. Best regards.

avatar

sn4k3

August 19, 2020, 10:20 pm

Quote:
Hi, That is a 2 flute. Best regards.
Thank you for replying. About the tip diameter should i use the full diameter of the tool (31.75mm) for the calculation? The tool don't have blades on all it radius, theres a small gap on center

avatar

Eldar Gerfanov (Admin)

August 19, 2020, 10:32 pm

I think you should use the full diameter.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here