By ktm3301
August 15, 2018, 2:35 am
negitive RPM on tap speeds??
I installed the desk top app s-80 F-6.15 v1.531 and the taps give negative rpm and feed?
screen shot
Latest Responses
- Circle/Ramp can't select ramp plunging
- Add TiB2 coating?
- Ball endmill/surfacing example
- Drilling - Cutting Force is Broken
- The RPM seems to max out at 10,000
- Tormach PCNC 440 / lower horsepower machine best practices for building CAM using Fusion360 and HSMAdvisor
- Am I using HSMA incorrectly?
- HSMA speeds and feeds with plastic and O-flutes
- High Feed end mill configuration
- molybdenum
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
ktm3301
I found the issue. when the check box on the machine def "calculations stick to predefined..." is check odd rpm are listed.
Eldar Gerfanov (Admin)
Hi, I will check it out. Thanks for following up with more information. I guess the calculated RPM is too far from the next RPM in the table and calculator does not know what to do.... Will fix it in the next update. Regards.