avatar

By Blue_Chips

September 22, 2014, 8:11 am

Slitting Saw

Hello Eldar
Is there a tool and settings that would be appropriate for slitting saws?

Thanks

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

September 22, 2014, 9:28 am

Hi,
You can use solid endmill tool type.

Just make sure you enter your arbor diameter as shank dia. Also enter number of teeth, helix angle=0. And stickout.

Watch for your power consumption and just to be safe, start with 30% feed override on the machine.

Everything depends on chip clearance, so be careful with flutes galling up.

Good luck!

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here