Resources and Software For High-Performance CNC Machinists
Email or Username:
Password:
Register Forgot Your Password?
Forums >>HSMAdvisor Support Forum >>Pyramid Engraver
avatar

By Otter

September 14, 2014, 11:02 pm

Pyramid Engraver

Is a pyramid engraving bit a three flute V-bit engraver? That is what I am using for now, but the cutting edge is rather obtuse compared to the typical cutter so I am not sure this definition works. Examples of the bit form are here, http://stores.ebay.com/SUPERWORKSHOP-BITBITWORLD/Carbide-Steel-Pyramid-Bits-/_i.html?_fsub=1541282012&_sid=942192292&_trksid=p4634.c0.m322 Thanks in advance, Bob

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

September 14, 2014, 11:09 pm

I have never used those in my life. So your guess would be as good as mine. I would try to run it as a 3 flute V-bit. It seems very strong.

avatar

Otter

September 14, 2014, 11:16 pm

So far, it also seems to leave a very nice finish at high speeds in wood. Bob

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here