Latest Responses
Username:
Password:
avatar

By cunder

August 19, 2014, 6:50 am

Helix Angle

Hi Aldar,

I have a question on entering the helix angle for the tool.
If the tool has a variable helix, such as 35° and 38°, do I enter the lower of the two or take an average.

Regards,

Charles.

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov

August 19, 2014, 1:08 pm

Hi.
The difference will only show in feedrate and will be minimal.

I would put 38 deg because that is what manufacturers often advertise.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here