Latest Responses

By Blue_Chips

April 8, 2013, 10:52 pm

Lathe infeed calculations request

Now that thread data is available it would be nice to see lathe infeed for the compound included and calculated.
Generally this angle is set to 29.5 but user input values would be good.


cant leave messages here
Pages:(1) [1]

Eldar Gerfanov

April 8, 2013, 10:59 pm

Will do.

It's actually getting harder to find place for new features rather than make them work.
I will see if its better to dedicate a whole page for turning calculations and move threading operation there.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here