Latest Responses
Username:
Password:
avatar

By Chris1050

February 25, 2022, 11:07 pm

Tormach 8L High Speed Profile

Tormach gave me some data to create a machine profile for the high range on the 8L which I have uploaded. Note: this is untested as I don't have an 8L to try this out on

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov

February 26, 2022, 1:16 pm

Hello,

Thank you for the upload!

I checked it out and it seems fine.

Best regards.

avatar

Chris1050

March 4, 2022, 9:10 pm

Hi Eldar,

Your welcome :)

I have uploaded the Low-Speed Profile based on some more Tormach supplied data. Again, this is untested as I don't have an 8L to try this on. The unknown is the cutting force the lathe can accept. In the profiles, I set the cutting force to 0 and the warning to 80%. I discovered that setting the cutting force in the profile to 0 doesn't override feed/rev.

avatar

Eldar Gerfanov

March 6, 2022, 2:46 pm

Quote:
Hi Eldar,

Your welcome :)

I have uploaded the Low-Speed Profile based on some more Tormach supplied data. Again, this is untested as I don't have an 8L to try this on. The unknown is the cutting force the lathe can accept. In the profiles, I set the cutting force to 0 and the warning to 80%. I discovered that setting the cutting force in the profile to 0 doesn't override feed/rev.


That is correct. In most places, 0 means "disregard the limit"

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here