Lately we've been doing alot of anvils out of 3/8 or 1/2" Hardox steel (Rc 45-50)
Aside from having to machine profiles and pockets we also have to drill some mounting holes.

Here are the speeds and feeds for supercobalt minicut end mills.

Here is a list of Okuma G and M codes i got from the manual

Note Some codes may not be supported by your machine, all information is given as is and i dont give a ... if you break something.

Information given here is correct to the best of my knowlege

If you want OKUMA Lathe to repeat program several times you can use a subprogram or a conditional GOTO statement.

On Many Okumas subprograms is an option you have to buy, so we have to use GOTO statement.

Thats it 

This little code helps alot when using bar feeder and stuff like that.

If you are finishing a pocket with wall corners' radius close to the radius of a cutter. The tool tends to chatter, especially with longer tools and harder materials.

To avoid this you can do one of the following:

• When programming. After roughing the pocket and before finishing. Create a simple drill cycle with finishing tool to remove extra material from the corner. This way when finisher goes to the tight corner, the chatter will virtually disappear.
• Do the same with a drillbit. Before Roughing.

Hanita Varimill II Speeds and feeds Table

Plus Ordering information