Being a CNC Machinist/Programmer is sometimes more than simply creating a program and machining the actual part, often times it is about creating efficient and accurate fixturing.

In this little project:

I had to machine rectangular cut-outs and drill holes through an already-turned steel ring. Then I had to part each ring to 4 equal pieces.

There were about 100 such rings that worked out to 400 pieces in total.

After drilling holes on an indexer I had to machine a fixture to hold my part through 2 remaining set-ups.

First half of the fixture consists of the expanding mandrel:

The work-piece would be mounted on it like so. A hole on the side is used to properly position it:

Recently I had to machine a few pieces after turning.

Because the very top of the part was supposed to be machined off, I could not clamp through the central hole like I often do.

Decided to quickly turn an expandable washer out of aluminum and a plastic spacer that would collapse a little bit under clamping pressure and allow the part to sit firmly against the base of the fixture.

I liked this method so much I am going to do the same next time I have similar part to make.

See pics below.

Later on i will try to post some more pictures of other setups I did.

All the pieces apart Fixture, spacer, expandable washer, FH screw Workpiece mounted on