Subscribe to Blog
Email Address
 

Being a CNC Machinist/Programmer is sometimes more than simply creating a program and machining the actual part, often times it is about creating efficient and accurate fixturing.

In this little project:

I had to machine rectangular cut-outs and drill holes through an already-turned steel ring. Then I had to part each ring to 4 equal pieces.

There were about 100 such rings that worked out to 400 pieces in total.

After drilling holes on an indexer I had to machine a fixture to hold my part through 2 remaining set-ups.

First half of the fixture consists of the expanding mandrel:

The work-piece would be mounted on it like so. A hole on the side is used to properly position it:


The mounted part already has cut-outs machined in the first op on the same fixture.

After slightly tightening the screw, the second half of the fixture is installed. It keeps the 4 machined pieces in place after they are parted from each other:


Then the screw is tightened even more until I can no longer turn the top half of the fixture by hand.

Both the lower and the upper halves are machined to slide-fit to the work-piece, so that when the mandrel expands it clamps the work-piece against the upper half.

By the marks on the fixture you can see where machining was taking place.
And yes, I accidentally machined my fixture by crashing a small end mill into it - MasterCAM did some weird stuff with rotating my toolpaths and messed up the g-code.

Unfortunately I forgot to snap a picture of the finished part.
But I think it is clear from the sketch how it should have looked.

This is one of those cases when coming up with a fixture takes more time and effort than programming and machining the part itself.
And its fun!

Cheers!

Comments:
No Comments posted yet, be the first one!

New Comment to: Expanding Mandrel with Outside Support

Name: *
Solve Capcha:
*
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here