Subscribe to Blog
Email Address
 
Search for corner returned 1 results.
Pages:(1) [1]

Avoiding Chatter in corners of a pocket

January 3, 2011, 1:02 am by Eldar Gerfanov (Admin)

If you are finishing a pocket with wall corners' radius close to the radius of a cutter. The tool tends to chatter, especially with longer tools and harder materials.

To avoid this you can do one of the following:

  • When programming. After roughing the pocket and before finishing. Create a simple drill cycle with finishing tool to remove extra material from the corner. This way when finisher goes to the tight corner, the chatter will virtually disappear.
  • Do the same with a drillbit. Before Roughing.
Pages:(1) [1]
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here