Here is a video of a 3 flute Hi-performance endmill slotting aluminum 0.75" deep per pass.

Well, not entirely slottimg, more like pocketing, but the very first move is a full width slot.

Stepover is 0.4"

First i calculated the cut on HSMAdvisor.

Used 6061 aluminum as material and HP endmill at a tool type.

Tool torque and deflection limits were both set at 100% and performance slider was at maximum.

This is what it came up with:

S9127 RPM 125 IPM.

Full slot, 0.75" deep.

45 in^3/min mrr.

Looking at how easy it went i think i should allow for more load in my calculator.

If you have not yet tried HSMAdvisor, make sure you do.

You will be amazed at how much productivity you have been missing out on.

Recenty ordered a 3Flute High Performance End Mill From NIAGARA.
Was very glad and slightly surprised that when punched in all of the endmill's data into my Calculator nothing broke down.I had a rason: At 5000RPM and 3/8" Deep slot cut. The feed came to around 92.0IPM. Chips were making this nice ringing noise that sounds like money.

Setup:
HAAS VM-3
Hudrolic Tribos Holder
3/4" 45DegHelix 3Flute 1.625FluteLen, 2.375"Overhang TICN HP End mill

S:5000RPM
F:92.0IPM
DOC: 0.375" Slotting
Coolant:FLOOD

The calculation was pretty much dead on.

Out Company used to have somebody else plasmacut cutting anvils for us.
This was expensive, plus heat generated by plasma caused already unstable anvils to warp like crazy making them very hard to grind flat.

So when foreman told me to machine one on CNC i immidately asked him to buy one of those nifty Hanita TiALN coated Varimill cutters.
Too bad they are too expensive. So the company bought same style of cutters made by Niagara. 0.5" end mill there is x3 cheaper than hanita's. Plus i believe cutting tools made to the same specs, out of the same materials are performing identical.

The machine we ve been using for this is really shaky and busted, so dont laugh at speeds and feeds that we came up with.

So basically, Specs Are:

• Material: Hardox pre-hardened steel Rc 45-50
• Cutter: 4 Flute, Stagger Flute TiALN coted 0.5" Micrograin Carbide End Mill, 2.5" Overall, 0.625" Flute Length, 1" overhang
• Operation: Slotting
• Speed: 1200 RPM
• Feed: 4.8 IPM
• Depth OF Cut: 0.125"
• Plunge method: 2.5 Deg Ramp/Helix, Or Plunge into 0.281Dia pilot hole at 3 IPM
• Coolant: Airblast + Oil