Optimizing Peck Drilling for Deep Holes

Peck drilling is often necessary when machining deep holes. However, with the correct feed and speed settings, pecking is unnecessary for depths up to:

• 3× diameter for standard drills
• 5× diameter for high-performance parabolic drills

For deeper holes:

• Up to 10× diameter → Up to 5 pecks for regular drills, and up to 3 pecks for parabolic drills
• Beyond 10× diameter → Constant pecking is required:
  • 0.5–1× diameter per peck for regular drills
  • 1.5–2× diameter per peck for parabolic drills

Since programming requires specifying a peck amount, here are the recommended values:

Read More 

Renishaw OTS tool probe cycle for HAAS can set both length and diameter offsets.

Too bad there is no choice: it only puts absolute measured diameter of the tool into D- diameter offset and makes wear offset=0

But if your programming is done with the center of the cutter, then you actually only need the difference between actual and programmed diameters of the tool.

I.E.: When probing 5/8Dia end mill, we get D=0.6248. You would normally have to subtract 5/8 from it and leave the -0.0002 difference.

But there is an easier way

Read More 

Problem: Work offset G54 Z0 shows some "weird number" which is very hard to relate to.

Can we make top of fixture show Z0=0.000 ?

Solution:

Read More