Subscribe to Blog
Email Address
 

I have been hunting for a very rigid but small machine for the last year or so.

And when I finally found one for sale on an auction in Minnesota, I could not pass.

Now the machine is in my garage.

It is a surprisingly heavy machine with a solid epoxy granite frame.

The features are as follows:

  • 1.5HP 5000 RPM spindle
  • Closed loop servos on all axes
  • Power draw bar and a rack tool changer assembly

I built a table with casters for it and upon plugging it to a computer it turned out that.... It's dead!

The proprietary Animatics control in the back is not working, which means 95% of all electronics in the back must be replaced.

I was actually almost hoping for that because the original software is DOS-only. It is hardly convenient to work with it.

I want it to work under mach or LinuxCNC

So I ordered the required parts online and when all of them are here, I will start the retrofit process.

I will be documenting my process in comments.

Wish me luck!

20200815_172749.jpg 20200815_172749.jpg 20200815_172817.jpg 20200815_172817.jpg 20200815_173030.jpg 20200815_173030.jpg 20200815_172804.jpg 20200815_172804.jpg
Comments:
No Comments posted yet, be the first one!

New Comment to: ProLIGHT 2000 retrofit!

Name: *
Solve Capcha:
*
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here