Subscribe to Blog
Email Address
 
Search for ramping returned 2 results.
Pages:(1) [1]

A Total Guide into Plunging and Ramping

April 4, 2017, 7:33 pm by Eldar Gerfanov (Admin)

Before we start milling away our stock we first need to get down to the required depth.

This is not a problem with external features when we can plunge outside.

When machining closed pockets, however, we need to find a way to get down to the machining depth first.

As usual there are several ways to get the job done. The plunging methods listed here are not ordered by their preference.

For various machining operations on different materials some may be more preferable than others.

Straight Plunging into a larger Pre-Drilled hole

This is one the best ones in my opinion.
Very few machining modes can compete in effectiveness with drilling and this method will get you the best combined tool life on most materials and (in case of many deep pockets) the least machining time, even when tool change time is factored in.

Read More 

Plunging and Ramping Recomendations and Techniques

February 12, 2013, 1:03 pm by Eldar Gerfanov (Admin)

Quite often in order to start cutting in x-y direction you need to first plunge into the material.

Here is a compliled list of recommendations for different kinds of plunging that works in most if not all cases.

Plunge with center cutting endmill:

  • Regular Chipload/Number of flutes , half the cutting speed. (for 3 flute endmill divide normal chipload by 3)

Ramp:

  • Ramp Radius (For Helical ramping): .90-.95 of cutter radius
  • Ramp Angle: Indexed/non center cutting endmills: 1-2.5 degree; Center cutting endmills- Up to 45 deg

Ramp chipload ajustment for 4 flute Center cutting endmills:

  • 0-2.5deg=100% of normal feedrate
  • 2.5-5deg=75% of normal feedrate
  • 5-15deg=50% of normal feedrate
  • 15-30deg=25% of normal feedrate
  • 30-45deg=5% of normal feedrate

Dont forget to reduce cutting speed for ramping above 5deg by half!

Pages:(1) [1]
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here