Subscribe to Blog
Email Address
 
Search for niagara,hpem,test returned 1 results.
Pages:(1) [1]

Niagara Elite HP 3 flute Hi Performance Endmill Test

September 18, 2013, 11:22 am by Eldar Gerfanov (Admin)

Here is a video of a 3 flute Hi-performance endmill slotting aluminum 0.75" deep per pass.

Well, not entirely slottimg, more like pocketing, but the very first move is a full width slot.

Stepover is 0.4"

First i calculated the cut on HSMAdvisor.

Used 6061 aluminum as material and HP endmill at a tool type.

Tool torque and deflection limits were both set at 100% and performance slider was at maximum.

This is what it came up with:

S9127 RPM 125 IPM.

Full slot, 0.75" deep.

45 in^3/min mrr.

Looking at how easy it went i think i should allow for more load in my calculator.

If you have not yet tried HSMAdvisor, make sure you do.

You will be amazed at how much productivity you have been missing out on.

Pages:(1) [1]
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here