Subscribe to Blog
Email Address
 

Some time ago an unknown colleague had borrowed an end mill from me.

Have i had been there i would have stressed that it was aluminum specific cutter and that it should not be used on steel.
Unfortunately i was not and it did not occur to him to ask somebody who would have known better.

Next time i look into my drawer i see this.(first picture)

Now we have a tool and cutter grinder to sharpen the OD of an end mill, but chips were so big, i would have to grind off maybe 20 thou of the diameter on order to get rid of them.

Our TC grinder does not allow to re-flute end mills, so i had to do it holding end mill in my hands.

First i picked up correct angle, and then i slide end mill upwards, turning it at the same rate as to follow flutes.

It came out better than i thought.
I was not planing to use it for finishing anyway.

And it lost only 5 thou in diameter after this hack-regrinding.

Before 13628531447330.jpg during 13628543442911.jpg after 13628543295750.jpg
Comments:
No Comments posted yet, be the first one!

New Comment to: One more way to Resharpen a chewed up endmill

Name: *
Solve Capcha:
*
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here