Subscribe to Blog
Email Address
 

HSM with MasterCam Dynamic Milling has long been one of my favorite toolpath strategies when machining hardened and tough to machine steels.

The job at hand was to machine out a 5" disk out of pre-hardened 4340 steel. About 43RC hard.
Due to an island in the middle (leaving only 3/4" room for the tool) I could not use a bigger indexed cutter, so i decided to use the adaptive clearing toolpath.

I started out by calculating Speeds and Feeds with HSMAdvisor and come up with the following starting parameters:

Full depth, at 10% engagement.

Which worked just fine. But the tool was not new and I decided to sacrifice it in the name of science and maxed it up to see how long the tool was going to handle it.

So I adjusted the cutting speed to 170% and feed to 150% (which accounts to heavy roughing):

To be honest I was not sure the tool was going to last very long, but it exceeded all my expectations!
It lasted for about 2 hours and completed the whole run of more than 20 pieces.

I even took a video cutting one of the parts:

Note how there are no sparks coming out. This is because the chip is thick enough to not overheat. This works both ways. Chips stay cool and due to their larger mass carry most of the heat away from the cutting edge.

After the end of the run (and it was not new to begin with) the tool looked like it could do as much!

--Eldar Gerfanov

Comments:

Pages:(1) [1]
avatar

By GWSchultzRep

October 6, 2016, 10:46 am

Thats great! this app is my salesmen secret weapon. i wish it took toolholder into consideration and fixturing. or even better would be to have a drop down for which CNC machine you are running on and a sub menu for its condition. i dont ask for much.... 
did you try at 6% to see how fast it would go and what the metal removal rate would be?

avatar

By Eldar Gerfanov

October 6, 2016, 10:16 pm

Hello,
Thank you.
It does not take the holder because i assume holder is adequate for the tool and that the tool will fail before the holder does.
Same thing with the material. It is up to the machinist to consider clamping.
BUT!
You can use productivity slider for flimsy setups. Just move it all the way to the left and you will get much lighter suggested cutting parameters.
Its function is to adjust for the flimziness in the holder/setup.
Regards.

No. I only ran it at 10% because the DOC was below what I would like to use for better MRR.
Normally you would want to have at least 2x depth of cut when HSM-ing.

New Comment to: HSM Machining pre-hard 4340 at 900 SFM

Name: *
Security Code:
*
 
© 200908:53:46-2016 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use. You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here