I don't see anywhere in HSMAdvisor to where climb vs conventional milling is either input or recommended. Wouldn't there be a difference in speeds & feeds based on climb vs conventional? Thanks.
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Hello,
I recommend always using Climb.
If you still want to use conventional, consider reducing speeds and feeds by 25%.
Also some machining modes could become near impossible. For example dynamic milling or those fancy HSM toolpaths don't work too well with conventional machining.
Best regards.