Tormach gave me some data to create a machine profile for the high range on the 8L which I have uploaded. Note: this is untested as I don't have an 8L to try this out on
© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here
Eldar Gerfanov (Admin)
Hello,
Thank you for the upload!
I checked it out and it seems fine.
Best regards.
Chris1050
Hi Eldar,
Your welcome :)
I have uploaded the Low-Speed Profile based on some more Tormach supplied data. Again, this is untested as I don't have an 8L to try this on. The unknown is the cutting force the lathe can accept. In the profiles, I set the cutting force to 0 and the warning to 80%. I discovered that setting the cutting force in the profile to 0 doesn't override feed/rev.
Eldar Gerfanov (Admin)
Your welcome :)
I have uploaded the Low-Speed Profile based on some more Tormach supplied data. Again, this is untested as I don't have an 8L to try this on. The unknown is the cutting force the lathe can accept. In the profiles, I set the cutting force to 0 and the warning to 80%. I discovered that setting the cutting force in the profile to 0 doesn't override feed/rev.
That is correct. In most places, 0 means "disregard the limit"