Latest Responses

By Thomas91

December 28, 2020, 6:58 pm

Calculating V-bit engraver

Good afternoon! I am a beginner and would like to know if I did everything right. I would like to ask you if I calculated the feed rate correctly for my ve-shaped cutter? I attach pictures. Is it just me or is the feed rate too fast?

Screenshot_25.jpg Screenshot_25.jpg Screenshot_24.jpg Screenshot_24.jpg

cant leave messages here
Pages:(1) [1]

Eldar Gerfanov

December 29, 2020, 10:03 am


No, you are not setting up your cutter correctly.

Please use the Tool display to visually confirm what your tool looks like.

Best regards.

2Flute90DegRouterBit.PNG 2Flute90DegRouterBit.PNG

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here