| 57 topics |
144 answers |
General DiscussionDiscussions on general subject, as well as questions and suggestions concerning FSWizard in general Last activity in:Dry vs wet SFMby: Eldar Gerfanov on November 24, 2018, 6:36 pm |
| 18 topics |
33 answers |
FSWizard:Online DiscussionSupport forum for FSWizard:Online Last activity in:Inch tool diameter incrementsby: JackWSmach on January 11, 2019, 9:46 am |
| 211 topics |
713 answers |
HSMAdvisor Support ForumHelp, Suport and Discussions related to HSMAdvisor Speed and Feed Calculator Last activity in:Tool Type V-Bit Engraver Table Questionby: cobra514 on January 21, 2019, 4:04 pm |
| 11 topics |
25 answers |
FSWizard:Android and iOS Support ForumSupport and discussion of our Android and iOS version Last activity in:Flycutter (Tool Type)by: Tonkatim on January 20, 2019, 3:19 pm |
Resources and Software For High-Performance CNC Machinists
Latest Responses
- Tool Type V-Bit Engraver Table Question by cobra514 on January 21
- Small feature request for my convenience :) by Eldar Gerfanov on January 21
- Flycutter (Tool Type) by Tonkatim on January 20
- Few questions by Yosiu on December 9
- Tapping by Eldar Gerfanov on December 3
- WOC and DOC by serge.nelissen on December 3
- Cross section by serge.nelissen on December 2
- Generic materials by serge.nelissen on December 2
- Tool info by Eldar Gerfanov on November 29
- New layout? by ndlsjk on November 28
- mm dimension for chip load and all other dims in inches by blcavender on November 27
- Dry vs wet SFM by Eldar Gerfanov on November 24
- Feeds and speeds for countersinks by Eldar Gerfanov on November 19
- What does the slotting option do? by Eldar Gerfanov on November 12
- New computer by Fueler on November 2
- Bring back editing Chip load/RPM/Feed directly by Unr3aL on October 25
- zirconia feed by wec-design on October 25
- Tapered cutters by Eldar Gerfanov on October 2
- Tool Library/Mahine Definitions by Eldar Gerfanov on September 25
Project Support: Please Register to participate. Select a category and post your question!
| 1707 views |
Welcome to Support ForumsBy Eldar Gerfanov on January 24, 2015, 12:18 pm |
© 2009-2018 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.
You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here