Subscribe to Blog
Email Address
 

Problem: Work offset G54 Z0 shows some "weird number" which is very hard to relate to.

Can we make top of fixture show Z0=0.000 ?

Solution:

  1. Go To Setting 33 (coordinate system) and Set it to HAAS. This will prevent G52 from clearing upon RESET or machine powerup and so on. (note: normal probing routines will require this setting to be Fanuk only).
  2. Find actual Z0 offset of your fixture and enter it into G52.

Thats it, from now on the value you enter into your G54-G59 Z is actual distance from top of your fixture to the top of programmed part.

Note: AGAIN this solution will not work with any of the probing software. The workaround for that will be posted later.

Comments:
No Comments posted yet, be the first one!

New Comment to: HAAS: Making G54-G59 show Z0 at the top of fixture

Name: *
Solve Capcha:
*
Sing In

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here