avatar

By mbele

October 10, 2016, 5:48 pm

How does depth of cut affect feed rate calculation ?

Hi,

when DOC is increased, calculator reduces the feed rate.
Eg.6061-T6 8mm 1fl carbide 45deg length:35mm flute-length:22mm WOC:0.5mm maxrpm:24K HSM:enabled
DOC:10mm feed:7280
DOC:20mm feed:3640
above 8mm DOC (tool dia), feed start to drop off, maintaining constant MRR/power/torque. Would higher feed rates break the tool (increase in torque/deflection)?

Great tool, btw :)

Regards,
Mihael

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

October 10, 2016, 11:14 pm
Updated by: Eldar Gerfanov (Admin)March 25, 2017, 3:17 pm

Hi,

Yes, higher feedrate will increase the deflection.

And yes. At some point it will lead to something breaking.

The online calc tries to maintain the same deflection on the cutter regardless of its length thus playing it very safe.

My other calcs like HSMAdvisor allow to sacrifice deflection for better MRR because they consider how much tool can deflect before snapping.

Regards.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here