avatar

By mofosheee

January 6, 2015, 11:30 am

just purchased F&S calc

Would somebody please back me up on the following:

0.375" solid 2 flute Carbide endmill, pocketing to 1" on 7075-T6 Al

using a 1.5HP machine I'm receiving readings of @ 3500 rpm, Feed = 21ipm with plunge of 10.5 ish.

Would somebody please review that my readings are in the ballpark?

Thank you

Jerry

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

January 6, 2015, 12:09 pm

Hello,

I assume you are limited by the available RPM.

Speed and Feed is OK.
You did not specify depth of cut. In your case i would suggest starting from about 1/8" DOC

Make sure you use coolant or airblast to clear the chips.
Aluminum tends to stick to cutting tools if no lubrication is used.

Good luck!

avatar

mofosheee

January 8, 2015, 9:53 am


Will be using coolant,

cutting to 1.25" depth. I can speed up the rpm's to 5000

Thank you!

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here