avatar

By Blue_Chips

August 21, 2014, 1:21 pm

Ball nose in tool type missing?

Hi Aldar,
Am I overlooking something? don't see Ball Nose listed in the "Tool Type" selection drop down.


Ken

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Blue_Chips

August 21, 2014, 1:35 pm

Never mind Aldar, found the ball nose selection tick box under tool data.

Ken

avatar

Eldar Gerfanov (Admin)

August 22, 2014, 11:12 am

Scared me for a second there!:ohmy:

avatar

Blue_Chips

August 22, 2014, 4:50 pm

Then my work is done :D

What are point micrometers used for, this one has two 60º comical points at each end?

Ken


avatar

Eldar Gerfanov (Admin)

August 22, 2014, 7:04 pm
Updated by: Eldar Gerfanov (Admin)August 22, 2014, 7:06 pm

Quote:"BLUE_CHIPS"
Then my work is done :D

What are point micrometers used for, this one has two 60º comical points at each end?

Ken

Dunno. Anything that needs those conical ends to fit into something.
I am thinking about measuring wall thickness of a tube, and of a thread diameter.

Very specialized i think. Never used one like that. Never even seen one in real world.

Eldar

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here