avatar

By cncworkdork

August 16, 2013, 1:19 pm

minimum RPM

I love this calculator. I run a table router and this is a life saver any time I cut something new (which is about twice a week). The only thing that would make it better for me is if it had a high AND low rpm limit. My spindle bottoms out at 4000rpm and I'm not sure how to approach a recommended feed rate when the recommended speed is below this.

Answers:
cant leave messages here
Pages:(1) [1]
avatar

Eldar Gerfanov (Admin)

August 16, 2013, 2:59 pm
Updated by: Eldar Gerfanov (Admin)August 16, 2013, 3:01 pm

Hi. Thanks!
Minimum RPM is right now available on HSMAdvisor- the standalone version.
Online FSWizard does not yet have it. i will add it to the pipeline

As a fix you can play with SFM override until it hits your desired RPM.

After i sort out some things there will be a major rewrite of the online version. This feature will be included as well.

avatar

Tod1d

May 28, 2022, 5:25 am

I was just searching for this exact topic. I have a Shapeoko HDM, and min speed is 8000

I've been just interpolating and adjusting the feedrate to get a desired chip load.

one problem is the spindle doesn't have the horsepower to get too carried away, so I end up opting for a thinner chip.

I'm guessing since this is a 9 yr old topic, there is no intention to add the enhancement?

avatar

Eldar Gerfanov (Admin)

June 5, 2022, 6:00 pm

Hi,

This was requested about 2 times in these 9 years, so... I will add it eventually when I add machine profiles. But at this time there is no definite timeline. I got too many things on my plate.

© 2009-2022 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use.

You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here