Latest Responses
Login:
Password:
avatar

By mark6556

September 8, 2017, 10:48 pm

Plunge cutting with a milling bit

So I've been doing some plunge cutting with a milling bit. I don't see a check box for this.
Should plunge cutting be the same speed as slotting?(assuming DOC matching the diameter of the bit) If not, what is the rule of thumb?

thanks.

Answers:

Pages:(1) [1]

By Eldar Gerfanov

September 9, 2017, 3:15 am
avatar

Hi,

Doc will be irrelevant.
Just set your WOC and use your Plunge RPM and Plunge Feed values.

Regards.

Answers:

Unregistered user cant leave messages here
© 200908:53:46-2016 Eldar Gerfanov. All Rights Reserved.
© 2009 Eldar Gerfanov. Materials on this site are presented as is and are mostly for educational use. You may freely reproduce information presented herein without any consent from me, provided you include link to this site.
In case when i am not the copyright holder, you may want to contact proper owner of material. Anyway, they are freely available on the Internet.
If you hold the copyright right for any of the materials on this site and want them removed, please contact me here